Diamabrush Hardwood Coating Removal Tool

Diamabrush Hardwood Floor Coating Removal Tool easily removes gummed up finishes from wood floors. Old shellac, oil based varnish, adhesive and paint  that gums up your sanding discs and belts, use the Diamabrush Hardwood Prep Tool.

Removing Sticky Black Finish From Pine Floors

The “black death” -it’s every wood floors sanders worst job, edge sanding old pine floors covered with old shellac and varnish. Some floors, you’re lucky getting 12″ with a 24 grit before the disc is clogged up.These type of floors eat edger discs and belts. This tool will save you hours, and save you loads of discs. The diamond coated bladed don’t gum up, they quickly strip the finish off to bare wood, leaving the floor at about a 50 grit finish and ready for your belt or edge sander to finish off.

Keeps Your Sanding Machines Clean

These dirty sticky finishes are no good for your machine either. Black death sticks to top rollers, wheels and dust fan impellers creating chatter and wave in the floor. Nothing worse than running your cherished sanding machines over a floor full of crud, that’s a job for Diamabrush first.

Save Time, Money & Effort With Diamabrush Hardwood Prep Tool

The diamond coated blades are reversible so you can turn them over once they do become dull. When both sides are done, simply buy a new set of blades, not the whole disc.

15″ Tool Fits Most 15, 16 and 17″ Buffers

The Diamabrush Hardwood Prep Tool is 15″ diameter and fits most 16″ & 17″ (406 & 430mm) buffers once the correct clutch is fitted. we have clutches in stock to fit  Numatic, Woodboy, Bona, Wirbel, Klindex, Cleanfix and risers for the the Bona Powerdrive. Call us for advice on your buffer.